How to Replace Bathtub Plumbing
There are many steps to follow when learning how to replace bathtub plumbing. You may use a screwdriver to remove the drain flange and waste. Ensure that the handles are still eight inches above the bathtub. If you must remove the tub spout, you can use a flat pry bar to remove it. Some spouts also have a setscrew that needs to be turned counterclockwise to free it. Remove the old drain by turning it counterclockwise until it is no longer attached. If you are replacing the overflow plate, you may need a reciprocating saw. Then, use pliers to loosen the drain piping. Follow the manufacturer’s instructions and remove the drain flange. Once the drain is removed, install the new one by following the manufacturer’s instructions. Replace the overflow plate and drain shown with the new one. Locate the overflow flange and drain pipe. Connect these two pieces with a screwdriver. Make sure that they are level and that they are aligned. You can also use shingle shims to level the tub’s rim. Then, install the drain strainer onto the flange. Next, apply plumber’s putty under the drain flange. This putty is inexpensive and can be found at Home Depot. The next step is to remove the bathtub. Thankfully, this process is not difficult. Make sure to measure the width of the tub before you start, and remove any obstructions. Once the bathtub is free, you can unscrew the overflow cover plate. Then, remove the drain assembly. The mounting bracket may need to be removed as well. Once you’ve removed the drain and overflow plate, you’re ready to install the new tub. If you’re a beginner, you can try to remove the old bathtub yourself. However, if you’re not confident, you can always hire a plumber for the job. Having somaeone else to help you is recommended, as it is more difficult without the help of a professional. And remember to wear protective eyewear, work gloves, and hearing protection. Lastly, make sure that you check with the sanitation company before attempting the project. When replacing the spout, you should use plumber’s tape to secure the pipe. If you use other types of tape, you’ll damage the pipe. Next, you need to install a new tap. Install it over the old one. Use a tubing cutter to cut off the threaded fitting on the pipe. Then, install a slip-on spout over it. You may also want to replace the spout altogether. Installing a new bathtub requires some carpentry and plumbing skills. You can either do this on your own or ask a partner to help. Then, level the floor of the tub, slide in the new one, and then reconnect the pipes. This will take just a few hours. You can then enjoy the fresh, new bathtub. This is a great way to update the look of your bathroom. And don’t forget to take the time to learn how to replace bathtub plumbing, as you can save a lot of money. Click here to learn more about viessmann boiler service derby.