How to Use a Snake in Plumbing

If you need to clean out a drain, you may be wondering how to use a snake. This article will walk you through the process. Before beginning, however, you should know how to use a snake. Here’s what you need to know to get the job done right. First, make sure that the snake is positioned correctly in the drain. If the snake is too long, it can cause damage to the pipes. If you are working on a clog in a drain, first make sure that you wear safety goggles and rubber gloves. Also, make sure to have a bucket nearby. Once you have prepared your drain, insert the snake into the pipe. Be patient as it might take a few tries to get it to move. Once it has made contact with the drain, slowly crank the handle to make it descend. Before using the snake, you should flush the drainpipe with water. Make sure that you’ve soaked the snake head with a liquid drain cleaner. The cleaner will dislodge the obstruction. When the water runs out, you should try using a different solution to the blockage. For instance, a thicker drain cleaner may have chemical ingredients in it. Before you use the snake, it’s important to flush it first, as it may splash back into the drain. Once you’ve done this, it’s time to begin unclogging the drain with the snake. The snake will reach the blockage and begin to rotate through it. If you notice a mass of gunk, it will be harder to turn. If you find the blockage is solid, continue cranking the snake a few more times until it grabs a good hold of the clog. If you’re successful in unclogging the drain, you should be able to use a pipe auger to unclog it. Once you’ve unplugged the water source and removed the trap arm, it’s time to insert the snake head. You should choose a drain snake with a slender cable and an auger head for maxeimum ease of use. Make sure to avoid using hot water, as it will damage the pipes and the drain snake. Finally, don’t force the snake down the drain, as this could cause it to break the entrance or the pipe itself. The snake should be inserted by hand or by a wall access point. Once you’ve successfully removed the obstruction, run cold water while you’re using the snake. There are several types of snakes. There are manual and electric ones. A manual snake is the easiest to use, but a power snake has a powerful auger that can easily escape an unskilled DIY plumber’s grip. Always be cautious when using a power snake with the power turned on as the auger can cause serious injuries. In case you’re unsure of the proper use of a snake, call a plumber to help you. Click here to learn more about boiler service derby.