How to Access Bathtub Plumbing
If you have a tub, you may be wondering how to access bathtub plumbing. First, you need to determine the best location of your access panel. It should be located between studs, preferably inside the walls. Afterward, cut a small hole for the tub access door and place it in the drywall. Once you have it positioned, you can begin the installation process. Next, you’ll need to install a stopper and an overflow lift rod. Most bathtubs don’t require an access panel, but it can be a useful asset. These panels can be found in nearby rooms. While newer houses don’t typically have access panels, older homes may have them. If you’re installing a bathtub, it’s important to maintain access to the water supply pipe and drain clean-out. You also need to be able to access compression fittings to repair them easily. Lastly, bathtubs with motors and auxiliary heaters may need an access panel. To replace a tub drain, you will first need to remove the access panel. Next, remove the old gasket, which is often a rubber gasket. You’ll need a flathead screwdriver to pry it out. Care must be taken not to damage the drain elbow, which may be difficult to reach. Once the old gasket is out, insert the new gasket. You’ll need to access the tub’s underside to install the new gasket. Once you’ve removed the stopper, you’ll need to remove the knob. You can do this by lifting the lever at the back of the tub. Then, use a dry rag and a sturdy screwdriver to pry it out. Depending on the size of your tub, you might need to use pliers or a screwdriver to remove the stopper. If the stopper is not removable, you may need to hire a plumber to do it for you. If you have trouble accessing bathtub plumbing, you can remove the panel. This panel is often installed during new construction. They are often made of plastic or plywood, and are located behind plumbing walls. Installing these panels will help you access the plumbing easily when you need to make repairs in the future. A plumbing access panel also provides a convenient access point if you need to make a faucet change later. When you have completed your plumbing work, you’ll have access to the pipe without having to break the wall. The flange on the drain assembly is located underneath the tub. It is connected to the main drain pipe located in the bathroom wall. It has a threaded nut on its exterior side. Unscrew this piece carefully. A sturdy screwdriver is essential to remove the flange. When you’re done, you’ll need to replace the drain flange. You can use this tool to clean your bathtub drain. Installing a bathtub is a complex job. Even if you’re an experienced plumber, you may not be able to tackle it yourself. If you have any questions or are not sure how to access the bathtub plumbing, call a plumber. A plumber will ensure that you have the correct tub installed correctly. You may have to remove the plastic cover from your bathtub. Then you can reuse your old bathtub accessories. This is where bathtub plumbing is accessed. Click here to learn more about gas plumber derby.