how to install a pedestal sink with floor plumbing

How to Install a Pedestal Sink With Floor Plumbing

If you’ve decided to purchase a pedestal sink for your bathroom, you may wonder how to install it with floor plumbing. The installation process is actually quite simple. You just need to follow some simple steps to make the installation go as smoothly as possible. You’ll need to prepare the space in which you want to install your sink, remove the old sink, and mark the wall where you’d like it. If you’re unsure about the height of your mounting bracket, consult the instructions for the pedestal sink’s mounting plate. how to install a pedestal sink with floor plumbing

First, make sure you remove any old drywall and plumbing before mounting your sink. Use a level to make sure your mounting plate is level. Use angle-drive screws and lag bolts to secure the mounting plate. If you don’t have these fasteners, use the lag screws provided with your sink’s mounting bracket. Remember to follow the installation manual and make sure you use heavy-duty fasteners.

Next, install the mounting bracket of the pedestal sink. The mounting plate is easier to install if it comes with screws. After that, open the valves to check for leaks. If you haven’t done so already, use heavy-duty fasteners in place of lag screws. Then, insert the lag screws into the predrilled holes in the wall. Tighten the screws alternately until they’re snug.

If you’re installing a pedestal sink on your own, you can start by removing the old one. It may require help because the front of the sink might need to be lifted. Be careful not to pull the front too hard or you’ll cause a leak. If you lift it too quickly, it may cause damage to the pedestal and sink. This process may take a few hours, but the final result will be a fully functional pedestal sink with floor plumbing.

The next step involves attaching the sink to the mounting board. The sink mounting plate may include lag screws. If so, remove them. This will give you more flexibility in installing the pedestal. The lag screws that attach the sink to the pedestal can also come from the manufacturer of the sink. Remove these screws to give yourself more flexibility in the installation. You can then use silicone sealant to make the base of the pedestal flush.

Before you begin the process of installing the pedestal sink, make sure you know the proper height of your drain. Measure the distance from the floor to the sink’s base. Make sure that it is slightly higher than the floor. Once the drain is installed, you should install the P-trap and pop-up drain. If your drain is too high or too low, you’ll need to add a few inches of height to your sink’s mounting brace.

Once the new pedestal sink is in place, you need to reroute the water pipes to make room for the new sink. You’ll need to remove a section of wall covering to access the pipe, install wood backing, and repaint the wall. To remove the existing drywall, you can use a keyhole saw, cutting it along the wall studs. Be careful not to hit the pipes or wiring when cutting through the drywall, as it can be difficult to maneuver the sink without damaging it.

Click here to learn more about boiler installation quote derby.

Call for a no obligation quote

Perhaps you’re concerned about your budget and finances when it comes to home improvements. If this is the case, give us a call about your budget, and we will offer you a free quote without any pressure. We will also work with your budget to ensure you get the desired fence.